Press enter to search.
I enjoy a lot fixing priners problems
docukaaf posted an answer for this Xerox WorkCentre 7120 Color Copier Printer 20 ppm, WC7120":
"IOT speed mismatch execute nvm read write 700-600, 700-601, 700-602 the 3 values match?"
docukaaf posted an answer for this Xerox Office Equipment & Supplies:
"Black toner dispense fault. Check for obstructions on dispensation of black toner to the..."
"There is aproblem whith the transfer belt unit"
"Just check that the fuser exit sensor is ok. If not try to change it or the complete fuser"
"The fuser reach one overtemperature
Enter diagnostics NVM dc 131 and fix (744-220)=0 and..."
"There is a problem with mcu. Try reconect mcu plugs"
"Select system conf"
docukaaf posted an answer for this Xerox WorkCentre 7556/P Copier:
"You have to reinstall the software whit the usb firmware to reset the bloked machinne"
"Your xerox 700 has problems with laser scan YM drive control.
Check that the connectors on..."
docukaaf posted an answer for this Xerox Phaser 3200MFP/N Laser Printer:
"The laser unit is not working. It has to be changed"
"Some files on fiery disk drive are corrupted or missing. Try reloading SW on it whit one..."
"No it has lot of paper and dirty powder."
"Try shorting the chip inside the fuser module. It has three fuses and when its life end,..."
docukaaf posted an answer for this Xerox DocuColor 12 Printer:
"Yor probles is caused for a pour conection from the fiery with the printer. Check..."
docukaaf posted an answer for this Xerox Phaser 7700 Laser Printer:
"Error 11, laser unit polygon motor failure. If this fault reoccurs 3 times successively..."
"This problem is common when heavyweight paper is fed from the tray long edge first. and..."
"Your docucolor has a problem whit the transfer belt. It may be damaged or out of position...."
docukaaf posted an answer for this Xerox Phaser 4500 Printer:
"Hy, this problem is caused because the print cartridge is out of range. try changing with..."
"Change the magenta developer, maybe some ink was not original"
"Hy the problem is: You have to clean the 2nd BTR and the transfer belt cleaner. There is a..."
"Well that problem is because there is not enought oil on the fuser roll. The problem is..."
"10.356 external heat roll retract failure. Try to release the external heat roll maybe..."
"The low toner sensor detects that is not cyan toner for a period of 8 minutes. Probably..."
"4.332 belt position failre as you can see the belt edge sensor sa detected that the drive..."
"The problem is because it has a bad or missing conection with the fiery. Try to reconect..."
"Hy, your dc 12 has a problem whith the ac driver pwb is the one with some relays on it..."
docukaaf posted an answer for this Xerox DocuColor 3535 Copier:
"I have got the new one it cost about $400 usd i you want i show you how to change...."
"Hi, its seems to be a defective print cartidge especically the scorotron grid. Take out..."
"Hi, you have to reset this code entering into diagnostic mode, If this fault is declared 3..."
22,673 people helped
View all achievements