The Office Equipment & Supplies - Recent Questions, Troubleshooting & Support
Imagerunner2520, it displayed loadpaper while have paper in the tray why
Hi there. There are a serious of steps in order to troubleshoot this type of problem.
First off, have you changed the type of paper recently being used?
Have you checked the paper guides to make sure they are secure and fit to the paper snug without bending the paper?
Have you cleaned the rollers with distilled water?
Have you unplugged the Imagerunner 2520 for 30 seconds without shutting down the printer plugged it back in?
I also did some research on similar canon products. This could be a printer device setting. Here are the steps:
From the Home menu, select "Setup". From there you can select "Device Settings" to access the Plain Paper Feed Settings adjustment.
- You select setting
- Device Settings
- Plain Paper Feed Settings
- Set up on Rear Tray instead of cassette
Also check to see if a test page prints. This could also be a printer driver problem.
10 hours ago
I have an old Husqvarna Viking 630 sewing machine. I would like advice on how to remove the front cover and availability of electronic control board.
First, you have to remove some screws from underneath the sewing machine. There are one or two small Phillips head screws and one or two, possibly three (I am writing this from memory) larger hex head ones. If you have the back cover off, you can see where the motor screws are: you do not need to remove them. then pry or pull of the large knob. You will notice that the hole in the front that the knob came from is oval, it extends downward from the knob shaft: that allows you to slide that part of the front upwards and off. The left side either comes up or moves to the right to release. However!! Are you sure you need to open this? The three dials you then have access to can be difficult to realign if they separate from their linkage, and there is not much that you gain from this maneuver.
3 days ago
Not finding what you are looking for?