Recent Questions, Troubleshooting Help & Support - Page 4


Honda Ridgeline? Check code, probably an ABS sensor

Cars & Trucks | Answered 2 hours ago


Remove the panel on the inside and should be able to release and access bolts that secure the handle

Cars & Trucks | Answered 2 hours ago


Manual transmissions usually don't have dipsticks, there should be a fill hole. Slipping is going to be a clutch problem or might check your clutch slave cylinder level.

Saturn Cars &... | Answered 2 hours ago


Check your local library, they have Motor and Chilton manuals. You didn't mention what kind of vehicle but some use shoulder bolts that just get tightened and not torqued. I hope this helps. Take care.

Cars & Trucks | Answered 2 hours ago


Location of CHT sensor. It is located at the back of the passenger side cylinder head close to where the intake manifold and head meet.It will have a YE/LG and GY/RD wires to it.

Cars & Trucks | Answered 2 hours ago


Parts store should have complete replacement

Nissan Cars &... | Answered 2 hours ago


Sounds like second gear went out, probably require rebuilding

Buick Cars &... | Answered 2 hours ago


Today Crosman owns Benjamin air guns. They offer a Free service to locate repair shops that repair airguns.

Cars & Trucks | Answered 2 hours ago


fixya site is not a medical forum
discuss the reading with your doctor in relation to your health

Health & Beauty | Answered 2 hours ago


Take it an have DTC'S - diagnostic trouble codes checked . Computer has codes stored . O/D light flashing indicates that .

Cars & Trucks | Answered 3 hours ago


I'm afraid not. 2018 Nissan rogue has 5 x 114.3mm pattern where the 2011 Kia Sorento is 5 X 115mm.

Nissan Cars &... | Answered 3 hours ago


Cut the 2 wires leading to the defective kickstand switch. If that solves your problem tape them up and hide them.
If it doesn't, connect the wires, tape them up and that will solve your problem.

If there is only one wire, cut it. If that solves your problem tape it up and hide it.
If it doesn't, firmly ground the wire and that will solve your problem.
Remove the bad switch.
If the problem persists, then the switch is not bad, something else is.

Motorcycles | Answered 3 hours ago


I assume you mean Tach (tachometer) and you are talking about a test device.
The test leads would normally be attached to the 2 little posts on the coil. You may also need to connect it to a power source.

Motorcycles | Answered 3 hours ago

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...