Dodge Logo

Dodge Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 796 Products
  • 331K Answers
  • 5M Views

maybe someone installed that valve cover backwards?? not even sure if thats possible??

Dodge Cars &... | Answered Yesterday


Hello... Maybe try another sensor...too many problems with non origin?l sensors...

Dodge Cars &... | Answered 2 days ago


That's called "limp-in" mode and indicates a major failure. Get it to a shop to have the trouble codes read

Dodge Cars &... | Answered on May 21, 2020


Here are some ways to bypass or reset the anti-theft system:
1. Insert the key into the ignition and try to start it up, it won't. Leave the key in the ON position for at least 10 minutes, you would notice that the security light blinks and goes away. Now, switch of the car, wait for five to ten seconds, and start.
2. With all doors and windows closed, put the car's key in the driver's side door to unlock it. Hold the key in the unlock position for at least 30 seconds; this tells the car that the right key is being used.
3. Disconnect both battery terminals for atleast two hours. Put the car key in the ON position and then connect both battery leads at the same time. Wait for 15 minutes, and the car should work fine.

2004 Dodge Neon | Answered on May 21, 2020


Find a fuse diagram printed on the back of your fuse box cover, or follow this link to know the placement of each fuse in your car: https://knigaproavto.ru/shemy/en/dodge/dakota/766-2002-2004-dodge-dakota-fuse-box-diagram.html

2001 Dodge... | Answered on May 21, 2020


Here are the specs you're looking for:
• Font axle to hub nut torque 185 ft-lbs
• Front hub bearing bolts 60 ft-lbs
• Caliper housing bolts 125 ft-lbs
• Caliper guide bolts 26 ft-lbs
• front spindle hub nut 97 ft-lbs
• lug nuts 100 ft-lbs.

Dodge Ram Cars &... | Answered on May 21, 2020


The yellow exclamation mark appears when your TPMS, AKA tire pressure monitoring system picks up on a low-pressure tire. It means that your tires aren't inflated to the recommended pressure. A simple fix is to inflate to the required PSI, and if the problem does not go away, drive down to the nearest garage, as you may have punctured tire at your hands.

2010 Dodge Grand... | Answered on May 21, 2020


Here is the link to view the serpentine belt diagram for 4.7 Dodge Ram 1500: https://serpentinebelthq.com/2004-dodge-ram-1500-slt-4-7l-serpentine-belt-diagram/

2004 Dodge Ram... | Answered on May 20, 2020


In tank fuel pumps have a sock style filter on their bottom that if not there a new pump can burn out quickly. If it is a replacement pump and not the whole assembly like the factory unit the hose from the pump to the housing can come off under pressure and spray all the fuel back into the tank. Lastly, but not to assume things since its easier to pull a tank without fuel in it does it have enough gas to reach the bottom of the fuel pump?

Dodge Cars &... | Answered on May 20, 2020


Well, the wire from the fuse goes to the relay in the power distribution center and from the relay to the fuel module. There could be a bad relay, bad fuel pump module or a wire that is grounding to the body of the car causing a short. Check the wiring harness where the wires go into the fuel tank.

Dodge Cars &... | Answered on May 20, 2020


The Engine Coolant Temperature Sensor is located in the coolant pipe, below the air intake pipe and behind the right cylinder head and is integral with the ECT sensor. The Engine Coolant Temperature Sensor is located on the back of the right cylinder head and is integral with the ECT sensor.
https://www.autozone.com/repairguides/Audi-Cars-1999-05/Component-Locations/Engine-Coolant-Temperature-ECT-Sensor/_/P-0900c152801c0f85

Dodge Cars &... | Answered on May 19, 2020


I have a 2008 Dodge avenger my lights was working and then his started flat by dash light started flashing now my brake lights won't work and my dash lights work work

2008 Dodge... | Answered on May 19, 2020


A diagram should already be available inside the hood on the radiator support of the fan covering. If not, follow this link: https://skippingtheinbetween.blogspot.com/2017/03/30-2006-dodge-ram-1500-serpentine-belt.html. Basically, if the pulleys are grooved, the belt ribs ride on it, and if the pulley is smooth, the backside rides on it.

2004 Dodge Ram... | Answered on May 18, 2020


I don't know - a call to the dealer would give you the information or you could read the vehicle handbook...

Dodge Cars &... | Answered on May 17, 2020


It sounds like you have a faulty park switch in the wiper motor. When it malfunctions, an electric current passes through the windshield wiper even when switched off. Also, bad wiring or a loose connection can also lead to the same outcome, and since the connection is not on par, the wiper may run in the lowest setting.

Dodge Cars &... | Answered on May 17, 2020


NO, IT IS A 2001
WHAT THEY MEAN IS YOU ARE LOOKING FOR THE O.E.M. PART # THAT STARTS WITH 529 AND THEN THE LAST 2 DIGITS SHOULD BE: -AD or -AF or -AF or -AK
THATS THE INFO THEY NEED!!
:-)

2001 Dodge Neon | Answered on May 14, 2020

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,243 Questions

1999 Dodge Durango
1999 Dodge Durango

-935 Questions

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

2000 Dodge Durango
2000 Dodge Durango

1,576 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,472 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Brad Brown

Level 3 Expert

18336 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...