Washing Machines - Recent Questions, Troubleshooting & Support

Possible solution - Check under the lid on the right-hand side about halfway. There should be a white plastic looking block slotted onto a couple of clips. This is the magnet that triggers the lid closed sensor. If it is out of place you will get this issue. Just fixed mine with exact same problem. Make sure it is slotted correctly into the grooves, Should sit flush. Good luck !

Washing Machines | Answered 1 hour ago

Check screens in hoses and in water valve for debris.

Samsung Washing... | Answered 2 hours ago

You didn’t give a model # but if your model has an actuator, I’d look at that 1st. If it’s not that, then it’s probably the transmission or agitator may be stripped out.

Whirlpool... | Answered 2 hours ago

Depends on model. Most are held on by a clamp.

Washing Machines | Answered 3 hours ago

there is still water in the waterproof tray at the bottom of the machine and the float switch has activated. pull the machine out (if pipes allow) and tip the machine backwards to drain the water from the tray.

Miele Novotronic... | Answered 10 hours ago

Maybe door seal / boot needs replacing

IFB Washing... | Answered 12 hours ago

Front door of what?

Washing Machines | Answered 12 hours ago

Not finding what you are looking for?
Washing Machines Logo

254,504 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1474 Answers


Level 3 Expert

83810 Answers

Brad Brown

Level 3 Expert

17758 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides