Audio Players & Recorders - Recent Questions, Troubleshooting & Support

Try asking these people:

Behringer Audio... | Answered 4 hours ago

Check out this website:

It can't be THAT difficult, the little kids there figured it out!

Ematic Audio... | Answered 17 hours ago

Hello Patt, the configuration of the speakers will depend on their height, surface to cover, and distance between them, as well as the amplifier to use
As an initial test, put the selector switch of each speaker for the 10-watt position and test the result
Depending on this test, you will have to raise or lower the power, to achieve the best coverage
I hope you serve the suggestion
Greetings Franco Dosil

Hola Patt, la configuracion de los parlantes dependera de su altura, superficie a cubrir, y distancia entre ellos, como asi tambien el amplificador a usar
Como prueba inicial, ponga la llave selectora de cada parlante para la posicion de 10 watts y pruebe el resultado
Dependiendo de esta prueba, tendra que subir o bajar la potencia, para lograr la mejor cobertura
Espero le sirva la sugerencia
Saludos Franco Dosil

Pyle Audio... | Answered 17 hours ago

Hello Bernard, your Pioneer AX-311, is a two-channel, stereo amplifier, you can connect your Samsung TV, if it has audio output L and R, to an input of the Pioneer, say for the AUX input, what will get, is to listen to the sound of the TV in your Pioneer, in stereo, two channels, you can not have surround sound, because your Pioneer does not have that benefit
At the most, you can hear the sound of Samsung on the TV and the amplifier simultaneously, and you will hear a sound delay between the Pioneer and the Samsung
I hope my answer was useful
Greetings Franco Dosil

Hola Bernard, su Pioneer AX-311, es un amplificador de dos canales, estereo, usted puede conectar su TV Samsung, si tiene salida de audio L y R, a una entrada del Pioneer, supongamos por la entrada AUX, lo que va a obtener , es escuchar el sonido del televisor en su Pioneer, en estereo, dos canales, no podra tener sonido Surround, porque su Pioneer no posee esa prestacion
A lo sumo, podra escuchar el sonido del Samsung en el televisor y el amplificador simultaneamente, y se escuchara un retardo de sonido entre el Pioneer y el Samsung
Espero que le haya servido mi respuesta
Saludos Franco Dosil

Audio Players &... | Answered 18 hours ago

Hello Jane, you are asking for a 490 Jensen CD, that your door does not close, because it is not locked with that action, or does not close because it does not reach the end of the route, so that it is locked?
In both cases, check that there are no 7 strange elements, inside the CD compartment and also that the door locking mechanism is in the closed position, making it impossible to close the door, in this case, using a thin element, you can unlock the lid closure by pushing it down and then stop pushing and check if the defect was corrected
I hope your answer has been useful
Greetings Franco Dosil

Hola Jane, usted esta preguntando por un CD 490, Jensen; que su puerta no cierra, porque no queda trabada con esa acci?n, o no cierra porque no llega al final del recorrido, para que quede trabada?
En ambos casos, verifique que no hay 7 elementos extra?os, dentro del compartimiento delo CD y tambi?n que el mecanismo de traba de la puerta se encuentre en la posici?n de cerrado imposibilitando que cierre la puerta, en este caso, utilizando un elemento fino, puede destrabar el cierre de tapa empujando el mismo hacia abajo y luego dejar de empujar y verificar si se corrigi? el defecto
Espero le haya servido mi respuesta
Saludos Franco Dosil

Audio Players &... | Answered 18 hours ago

Hello Wireko, you can connect any DVD player, which has output for SubWoofer, but you will only hear the bass, through the subwoofer, you would have to connect it to a 5.1 or 6.1 amplifier with their respective speakers, of the brand you want to be able to appreciate the other frequency ranges
hope you have served my suggestion
greetings Franco Dosil

Hola Wireko, puede conectar cualquier reproductor de DVD, que cuente con salida para SubWoofer, pero solamente va a escuchar los graves, a trav?s del subwoofer, tendr?a que conectarlo a un amplificador 5.1 o 6.1 con sus respectivos parlantes, de la marca que usted quiera para poder apreciar las dem?s gamas de frecuencias
Espero le haya servido mi sugerencia
saludos Franco Dosil

Panasonic Audio... | Answered 18 hours ago

i've had a similar problem where the fan stopped moving and the system gave the usual "protect" error. i think the IC's burned out on the amp board since the error was no longer there when i unplugged it. i ordered a new board off ebey for $25 shipped. make sure this is the problem by unplugging both the power and data cables from the amp circuit (the board with the big heatsink) and starting it. if it says starts normally then the problem is the amp circuit

Samsung HT-WP38... | Answered 22 hours ago

Hello John, before changing the belt, clean the surfaces where the belt will work?
You should clean the belt, with a little alcohol, on the plate, then clean the motor pulley, also with alcohol, if you can remove the plate, check that the axis of rotation does not generate jumps or hardening
I hope the information has been useful
Greetings Franco Dosil

Hola John, antes de cambiar la correa, limpio las superficies donde va a trabajar la correa?
Debe limpiar en el plato, el sector donde trabaja la correa, con un poca de alcohol , luego limpie la polea del motor, tambien con alcohol, si puede retirar el plato, compruebe que el eje de rotacion no genere saltos o endurecimientos
Espero que le haya servido la informacion
Saludos Franco Dosil

Audio Players &... | Answered 23 hours ago

power supply or something is shorted triggering it in self protection to turn off.

have a shop look at it.

Yamaha RX-V870... | Answered Yesterday

Hi, the two equipments are amplifiers, and the Sony is also Receiver, the possible connections are level, low signal and you can leave the "REC OUT" of the Sony and enter AUX in the Sansui, in this way, everything that comes in stereo on the Sony, will exit by rec out and enter the auxiliary on the Sansui
Hola, los dos equipos son amplificadores, y el Sony ademas es Receptor, las conexiones posibles son a nivel, baja se?al y puedes salir del "REC OUT" del Sony y entrar a AUX en el Sansui, de esta manera, todo lo que entra estereo en el Sony, saldra por rec out e ingresara al auxiliar en el Sansui

Sony Audio... | Answered Yesterday

Hello Judd, we would have to start at the beginning of the chain of elements that allow us to reproduce the disc
first, observe the capsule holder and verify the capsule connections, the standard says looking at the capsule connections, with the pua down, the red wire is the R output of the capsule to the right upper leg of the capsule, the cable white, output L, is connected to the upper left leg, the blue wire, output mass R, to the lower left leg and the green wire, output mass L, to the lower right leg
Having this in order, you should corroborate with the help of a tester, that each position indicated above be repeated in the connections of the arm, for which you would put the tester in continuity position and control that there was no short circuit among the living of the testers. channels in the RCA
This is to check, the connection from the capsule to the RCA connectors
If this is done, the problem persists, try the tray on another computer and see if the failure continues, if you do not have a problem in your phone's pre-phono

Hola Judd, habria que empezar por el principio de la cadena de elementos que permiten reproduccir el disco
primero, observa el portacapsula y verifica las conexiones de la capsula, el estandar dice mirando las conexiones de la capsula, con la pua hacia abajo, el cable rojo es la salida R de la capsula a la pata superior derecha de la capsula, el cable blanco, salida L, va conectado a la pata superior izquierda, el cable azul masa de salida R, a la pata inferior izquierda y el cable verde, masade salida L, a la pata inferior derecha
Teniendo esto en orden, deberias corroborar con el auxilio de un tester, que cada posicion indicada anterior mente se repita en las conexiones del brazo, para lo cual pondrias el tester en posicion de continuidad y controlarias que no hubiese corto circuito entre los vivos de los canales en los RCA
Esto es para comprobar, el conexionado desde la capsula hasta los conectores RCA
Si hecho esto, el problema persiste, prueba la bandeja en otro equipo y fijate si la falla continua, si no lo hace tienes un problema en el pre de fono de tu equipo

Sony Audio... | Answered Yesterday

Not finding what you are looking for?
Audio Players & Recorders Logo

320,616 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts


Level 3 Expert

5683 Answers

The Knight
The Knight

Level 3 Expert

76036 Answers


Level 3 Expert

84540 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides