Question about GE Washing Machines

1 Answer

My ge front loader washer does not start a cycle. its not coming in water

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Vr2020 Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GE Master
  • 63,377 Answers

CHECK SCREENS IN THE HOSES FIRST , THEN REPLACE THE INLET VALVES

Posted on Apr 10, 2019

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Ge Adora Front Loader

If you have not already done so, clean the filter behind the panel in the front bottom of the washer. Remove the three philips head screws to get the panel off. Unscrew the plastic filter on the right hand side (use a shallow cake pan to catch any water). Remove the filter and clean out the pens, pencils, change, lint, etc... and put back in. All should work well after this. Thanks, Greg

Posted on Jan 03, 2008

jgwhomeequip
  • 1902 Answers

SOURCE: moldy smell inside GE profle top loader washer

Check the pump and make sure that it is draining the water. There will always be a little water left over but you should never be able to hear it very easily. Once you check the pump and make sure it is operating properly check the water sensor to make sure that it is acuratly reading the water hieght. After that take one cup of Vinegar and run a hot load of water will kill the mold and clean your system out

Posted on Feb 21, 2009

  • 1 Answer

SOURCE: GE WCVH6260 Front Load Washer

I removed the three screws, and lower cover cleaned the few pennies, screws and nasty gunk build up from the filter. The wash machine seems to function as it did prior to the clogged issue. Thank you everyone !!!

Posted on May 31, 2009

  • 1 Answer

SOURCE: Washer doesn't run all the way thru cycles. It's

Removed hose connecting to water pump at tub. Removed clog (ink pen, coins, etc). Replaced and ran washer. Ran through all cycles - no leaking, no pausing of cycles. Problem is resolved.

Posted on Oct 02, 2009

TheMobilian
  • 8220 Answers

SOURCE: front loader washer machine will not drain all

I would check the pump for objects, clean the filter, look into the hose adjacent to the pump for objects slowing the flow. I have a manual for you: HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

GE GFWS3500LOWW not starting on any cycle


GE Washing Machine GFWS3500L0WW Troubleshooting ...

www.repairclinic.com/...-/GE-Washing-Machine-GFWS3500L0WW-Tr...
GE Washing Machine GFWS3500L0WW ... Washer fills slowly · Washer leaking water · Washer won't start · Washer won't spin or agitate · Washer overflowing ...
Repair Help - Model Help Repairwww.searspartsdirect.com/ge/washer/model-gfws3500l0ww-repair.htmlRepair Symptoms for GE Washer Model #gfws3500l0ww. Shop Parts ... Slow or noagitation or spinning ... Not working at all ... Clean Washer cycle won't work.GE front load washer door latch Repairwww.appliance-repair-it.com/front-load-washer.htmlIf your GE front load washer has a door latch problem such as the door will not lock or... You should always use HE detergent on any front load washer. ... manually unlocking the door and pouring cold water into the tub then start a new cycle.GE Front Load Washer Service modewww.appliance-repair-it.com/GE-front-load-washer.html

Jan 28, 2016 | GE Washing Machines

1 Answer

The motor is running but it won't turn the belt on my front loader ge washer


It definitely sounds like the belt is stretched, worn-out, and in need of replacement.

Jul 30, 2014 | General Electric Gfwh2400lww 4.9 Cu. Ft....

1 Answer

MY GE front loader washer won't fill with water or spin. I hear a hum when I turn it on and it sounds as if it's about to start a cycle but nothing happens.


It sounds as if your water valve is either clogged or the solenoid is stuck and not letting any water in. Here is a checklist of things you should do to help isolate the problem:
1) check to make sure the water is on
2) turn the water off and remove the water lines and verify that both the lines and the screens on the valve are clear of debris, calcium, etc.
3) take the top off the machine where you can actually see the valve, turn the machine on and see if the vavle is the humming noise that you are hearing. If so and no water is coming out then the valve is bad.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

May 19, 2012 | GE Washing Machines

1 Answer

GE washing macine stops during the wash cycle


This is exactly what my machine was doing, as well. I fixed it by cleaning out the filter in front of the water pump.

Searching here, I found that you can remove the lower front panel (three screws along the bottom edge is all it takes) to get to the filter. With the panel removed, you'll see a round white plastic cover (about 3-4 inches diameter) that screws out. Get a bucket under the cover to catch the water that's in it (could be 2 quarts or more) and unscrew the cover.

The cover pulls out, revealing that is actually a screw-in plastic strainer. I found tons of coins, broken pens, paper clips, etc. in mine when I did this. A lot will be deep inside the black rubber hose that connects this filter housing to the washer drum. You can rake the stuff out with a bent wire clothes hanger. Shaking the black hose will help hurry the junk along and out of your machine. Screw the cover back on after the clean out and your machine should go back to normal.

Thinking about it, front loaders will have lots of small items flushed into the pump compared to top loaders. Coins you alway found in the bottom of the drum in a top loader, they all wind up in the filter of a front loader. And once it slow the drainage to a crawl the machine will shut down multiple times when it can't drain the water out completely, and it will never step up to it's max spin speed with all that water still in the drum.

Nov 26, 2009 | GE Energy Star WCVH6260F Front Load Washer

1 Answer

Washer doesn't run all the way thru cycles. It's


Removed hose connecting to water pump at tub. Removed clog (ink pen, coins, etc). Replaced and ran washer. Ran through all cycles - no leaking, no pausing of cycles. Problem is resolved.

Oct 01, 2009 | GE Energy Star 3.7 IEC Cu. Ft. Front Load...

1 Answer

My front load washer does not seem to fill enough


At least on our GE front loader it is ok. That's why they are so easy on water.

Aug 17, 2009 | Frigidaire ATF6000ES Front Load Washer

3 Answers

There is a musty oder coming from inside washing machine.


Dump in a gallon of white vinegar, fill with water, highest setting, after it goes through that setting, turn it off and let it set in the washer for about 30 minutes (use hot water).

Then put it on another wash cycle and then go to the rinse and spin. This should remove the order, and you should leave the door open when not in use.

Good Luck

Aug 08, 2009 | General Electric WBVH6240HWW Front Load...

1 Answer

Can't see water level at all


Yes very normal in a front loader for clothes to be dripping wet but you may see little to no standing water.

Nov 02, 2017 | GE WBVH6240F Front Load Washer

1 Answer

Ge Adora Front Loader


If you have not already done so, clean the filter behind the panel in the front bottom of the washer. Remove the three philips head screws to get the panel off. Unscrew the plastic filter on the right hand side (use a shallow cake pan to catch any water). Remove the filter and clean out the pens, pencils, change, lint, etc... and put back in. All should work well after this. Thanks, Greg

Dec 15, 2007 | GE Energy Star WCVH6260F Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

geapptech

Level 2 Expert

157 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a GE Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...