Question about 2010 Chevrolet Equinox 1LT

1 Answer

2010 equinox power steering fluid

How to add power steering fluid

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

The 2010 v6 has a power steering dip stick below the engine cover. Take off the oil cap, grab the plastic engine cover on each side and lift it off (it snaps off and on). Put the oil cap back on so you don\'t lose it. You will see the power steering dipstick at the top of the engine. This only applies to the v6. Mine was loud, and I added a bit of fluid and it was fine.

Posted on Aug 14, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

SOURCE: adding power steering fluid

You do not add any. If the steering system is leaking,you repair the problem. It is a sealed system other than a removable fill cap. It does not use fluid in the sense you ever loose any

Posted on Sep 30, 2009

bunnydawg
  • 5158 Answers

SOURCE: How do I add power steering fluid to 2005 chevy equinox?

first and it's sort of obvious... make sure the motor is off.... look for a cap at the front of the motor where the fan belt is... may even be labled power steering ... you add the fluid there

Robert

Posted on Jan 29, 2009

  • 401 Answers

SOURCE: Need to put steering wheel fluid

Hi there is no power steering fluid in this vehicle
it has ELECTRIC POWER STEERING

Posted on May 13, 2009

  • 285 Answers

SOURCE: have a 2001 monte carlo where to put steering fluid

if this car has the 3800 or 3.8 ltr its on the passenger side towards the fire wall,the fill sits low in the back ,behind the engine,you might need a transmission funnel so you dont spill the p/s fluid all over the back of the engine,hope this helps

Posted on Sep 06, 2009

  • 61 Answers

SOURCE: where do you add power steering fluid?

The HHR does not use power steering fluid. The power steering is strictly an electric motor attached to the steering column under the dash. If you are having problems, you may need to have the motor replaced.

However, before you do, check the following fuses:

Underhood fuse #1 - 60A
Inside console fuse #19 - 2A

Either with kill the steering and may have been blown if you (or an uninformed mechanic) have jumped the car incorrectly.

Posted on Mar 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I add power steering fluid?


Maria, Link below explains where to add fluid. not your exact car but should be close. Look for a cap with picture of steering wheel or clearly marked steering fluid.
PRESS THE HELPFUL BUTTON and follow me on fixya for more info.

Follow These Steps to Add Power Steering Fluid to Chevrolet Impala 2006...

Follow These Steps to Add Power Steering Fluid to Buick Lucerne 2006 2011...

2009 Chevy HHR power steering problem

POWER STEERING HHR 06 PROB
PRESS THE HELPFUL BUTTON and follow me on fixya for more info.

Feb 10, 2016 | 2007 Chevrolet HHR

2 Answers

What power steering fluid do I put in my 1994 Toyota camry?


How Do I Check/Add Power Steering Fluid to My ... - YouTube

? 2:55
www.youtube.com/watch?v=mtQfJ31MLxk
Oct 21, 2010 - Uploaded by 1A Auto Parts Auto Repair: How Do I Check/Add Power Steering Fluid to MyCar or Truck? .... What type of power steering fluid could I use for my 2003 Ford Explorer? .... Toyota 4 Runner Steering Problem Returns - EricTheCarGuy ..

Oct 15, 2015 | Toyota Cars & Trucks

1 Answer

Ihave a car ford taurus year 1999 my problem is the power steering pump if ishot down the engine the fluid will come out wiht alot of preasure on the reservoir even though it was ina correct level, th


when filling the power steering pump, add enough fluid that you can see it inside the pump down low. turn the tires all the way to the left then to the right. then straighten the tires. this allows the fluid to go in to the system. add more fluid and check with the power steering cap level gauge. if the engine has warmed up add fluid to the hot level on the power steering cap gauge. do not overfill.

Feb 22, 2014 | Ford Taurus Cars & Trucks

1 Answer

Bleed power steering on 2008 dodge avenger


to bleed power steering, with front wheels off ground slightly with front wheels pointing straight ahead.engine off. remove power steering filler cap.add power steering until fluid level stop dropping,wait couple minutes and wait, add fluid until level stay at full cold mark on power steering cap dip stick. dont over fill.when fluid level stop dropping, start vechicle,let it idle few minutes. see if fluid level drop if so add more fluid full cold mark.then turn steering all the way to left and right with out hitting a stop.turn steering wheel several times, then turn front wheels pointing forward check power steering fluid level.if power steering fluid level stop dropping air should be out of system, if steering turning wheel dont turn smoothly and power steering fluid look light tan color air getting in the system.check all power steering lines to rack and power steering pump for leaks.be sure you replaced all the power steering lines with new o rings if not you will get a leak.if you find a leak, you need to fix the leak and bleed system again.dont drive vechicle if your steering dont feel right,have vechicle towed to a garage.

Aug 25, 2012 | 2008 Dodge Avenger

2 Answers

Where do i add power steering fluid


The power steering resover is under the alternator on these model cars your going to have look for it.

Feb 08, 2011 | 1995 Pontiac Bonneville

1 Answer

How to repair a power steering pump hyundai coupe 1996


SIPHON OUT POWER STEERING FLUID.USING A HAND PUMP SIPHON TYPE YOU BUY AT ANY AUTO PARTS STORES.PLACE DRAIN PAN UNDER CAR NEAR POWER STEERING PUMP CATCH FLUID WHEN YOU REMOVE POWER STEERING LINES AT THE PUMP.REMOVE DRIVE BELT.THEN REMOVE POWER STEERING PUMP.YOU NEED TO TAKE OLD PUMP WITH YOU.TAKE NEW PUMP AND OLD PUMP TO MACHINE SHOP THEY WILL REMOVE POWER STEERING PUMP PULLEY FROM THE OLD PUMP TRANSFER PULLEY TO THE NEW POWER STEERING PUMP YOU NEED TO BUY NEW POWER.STEERING HOSES O RINGS TO GO ON NEW POWER STEERING PUMP.HOSES THE OLD ORINGS WILL LEAK. THEN TAKE NEW POWER STEERING PUMP ON INSTALL IN VECHICLE THEN BLEED POWER STEERING SYSTEM.FILL POWER STEERING PUMP UP NEW FLUID.WAIT FEW MINUTES.WHEN LEVEL DROP ADD MORE FLUID UNTIL YOU GET TO FULL COLD MARK.START ENGINE 15 SECONDS SHUT OFF CHECK FOR LEAKS. NOW CHECK POWER STEERING AGAIN ADD TO FULL COLD MARK.NOW RAISE FRONT WHEELS OFF GROUND.START ENGINES TURN STEERING LEFT TO RIGHT WITH OUT STOPPING IT DO SEVERAL TIMES THEN CHECK FLUID.ADD TO THE COLD MARK DONT OVER FILL.IF FLUID LOOKS TAN HAS AIR BUBBLES IN SYSTEM WAIT A WHILE UNTIL FLUID SETTLE CHECK FLUID LEVEL.DONT DRIVE VECHICLE UNTIL STEERING FEELS NORMAL.AND IF YOU HEAR NOISES.LOCATE PROBLEM FIX BEFORE DRIVING VECHICLE.

Jan 24, 2011 | Hyundai Genesis Coupe Cars & Trucks

1 Answer

The power steering isn't working. The reservoir was empty and I added power steering fluid and it still very hard to steer


YOU HAVE A RUPTURE PRESSURE LINE IF YOU HAVE NO POWER STEERING FLUID IN THE POWER STEERING RESERVOIR.LOCATE LEAK THEN BLEED POWER STEERING SYSTEM BY ADDING POWER STEERING TO RESERVOIR.DONT OVER FILL BY FULL COLD MARK ON POWER STEERING DIP STICK.ADD FLUID TO RESERVOIR WAIT A 2 MINUTES.CHECK FLUID LEVEL AGAIN.WHEN POWER STEERING FLUID LEVEL STOP DROPPING.START ENGINE LET IT RUN FOR 10 SECONDS.THEN TURN OFF ENGINE CHECK POWER STEERING FLUID ADD FLUID IF FLUID LEVEL DROPS. WHEN FLUID LEVEL STOP DROPPING.SAFELY RAISE SUPPORT VECHICLE FRONT WHEELS.START ENGINE.NOW TURN STEERING WHEEL GENTLY FROM STOP TO STOP MEANING LEFT TO RIGHT DONT HOLD IN POSITION.LET THE STOP TO STOP BE QUICK.CHECK POWER STEERING FLUID AFTER YOU HAVE TURN STEERING WHEEL ABOUT 7 STOP TO STOP.WHEN FLUID LEVEL STOP DROPPING YOU AT HOT MARK ON DIP STICK BLEEDING PROCESS COMPLETE.TURN OFF ENGINE LOWER VECHICLE BACK TO GROUND WAIT ABOUT 5 MINUTES CHECK YOUR FLUID LEVEL.IF FLUID LOOKS LIKE A TAN COLOR.YOUR POWER STEERING SYSTEM FULL OF AIR.TURN OFF VECHICLE LET VECHICLE SET A LONG WHILE TO AIR BUBBLES SETTLE DOWN LOOK FOR LEAKS AROUND POWER STEERING PUMP FRONT SEAL AND CHECK FOR LEAKS AROUND POWER STEERING LINES.

Dec 01, 2010 | 1999 Oldsmobile Alero

1 Answer

Where to add power dteering fluid


POWER STEERING PUMP NEXT TO ALTERNATOR.POWER STEERING PUMP WILL HAVE COVER WITH DIP STICK.THE COVER WILL HAVE POWER STEERING FLUID WROTE ON IT ADD POWER STEERING FLUID TO THE COLD MARK ON DIP STICK DONT OVER FILL TO THE TOP.

Nov 10, 2010 | 2002 Pontiac Grand Prix

2 Answers

Power steering fluid in the 96 Kia Sephia.


there should be a resevoir on the passenger side of the vehicle. black cap, yellow or white in color resevoir. add dexron/mercon IV or better.

Nov 08, 2009 | 1996 Kia Sephia

Not finding what you are looking for?
2010 Chevrolet Equinox 1LT Logo

2,086 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...