20 Most Recent 2006 Chevrolet Equinox Questions & Answers

Reads like it might possibly be a poorly connected steering column harness connector, intermittent computer connection on one of the harnesses or other including connector damage from someone in the past that got frustrated while making a large connector "fit", causing pin damage and not quite locked harness connector.
Also, after so much time, cleaning of the throttle body opening is in order just in case you are dealing with an electrical problem, as well as a separate hard start issue. Cleaning the throttle body opening makes a big difference in general hard starts that clear when the accelerator is tapped with the key in the run position with the engine not yet started.

A good trusted garage or good dealership is going to be in order for this one.

2006 Chevrolet... | Answered on Jan 16, 2019

  • The pre-catalytic converter sensor (#1) is attached to the rear exhaust manifold, the post converter unit (#2) is accessible from under the car and is in the exhaust pipe.

2006 Chevrolet... | Answered on Jan 02, 2019

There's oil pressure building up in my 2013 Chevy Equinox 2.4 liter just wondering what's going on and how to fix it when I pulled out the dipstick when it was off it's sprayed everywhere

2006 Chevrolet... | Answered on Dec 17, 2018

There is no filter, unless you are referring to the screen filter on the fuel pump inside the fuel tank.

2006 Chevrolet... | Answered on Mar 25, 2018

You should go to www.reliable-store.com they have got books on every vehicle and also how to service/repair it,
service/repair/owner's/maintenance manual with
parts info, fuse box, gear box, torque specs,coiling, wiring diagrams, electrical diagrams, fuse diagrams, error codes, etc everything
Worth it

2006 Chevrolet... | Answered on Mar 15, 2018

solution for this online at www.reliable-store.com and get complete guide on whether to repair or not, service it, and how to repair etc

2006 Chevrolet... | Answered on Mar 12, 2018

charge bat on cigaret lighter fitting in car

2006 Chevrolet... | Answered on Feb 18, 2018

Are the heater hoses going into the passenger compartmet from the engine bay Hot ? What's the temp. of the engine coolant ? Go to harbor freight tools an buy a Non-Contact Infrared Thermometer With Laser Targeting . an test the temp of the coolant . Hook up a scan tool that can read sensor data an see what the PCM is seeing from the coolant temp sensor .
If the temp is good , heater hoses hot etc.... probably a temp blend door actuator .

2006 Chevrolet... | Answered on Feb 15, 2018

try this site autozone. they ahve a lot of wiring diagrams. jsut go down the list until you find your diagram.

Repair Guides Wiring Systems 2006 Power Distribution Schematics AutoZone...

2006 Chevrolet... | Answered on Feb 03, 2018

Need more info. Does it sputter or rev and not move. Also whst is ambient air temp

2006 Chevrolet... | Answered on Jan 10, 2018

Could you be more specific on what was fixed? and i would start by checking your fuses, do you hear any sounds when turning all the knobs? sometimes you can hear the heater flaps moving around when adjusting temp, the fuse for the fan probably is blown.

2006 Chevrolet... | Answered on Dec 21, 2017

Check the electrical connections for you control switches...there should be at least two of them. Disconnect them and see if there are any recessed pins or dirt. Do this several times as there may be some oxidation on the connectors and doing this will help clean them off. The radio and door light works of the small limit switch on your door frame. Everything else works through the operators window/door lock control panel.

2006 Chevrolet... | Answered on Dec 04, 2017

Looking at a wiring diagram to see what all is involved in the starter circuit's an testing with a DMM - digital multi-meter is how you go about diagnosing this . Free wiring diagram's here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model an engine size . Under system click on engine ,then under subsystem click on starting . Click the search button then the blue like. Looking at the diagram i see a starter relay ,ignition switch , PCM - engine computer ,the starter . The starter should have only two wire's , heavy gage red - this is B+ voltage for the starter . A smaller gage purple wire - this is the control wire . Do you know how a relay work's ? video's on youtube showing how . If the computer see's an input from the park neutral safety switch on no anti-theft system problems it will supply a ground for the starter relay , sending B+ voltage to the starter solenoid engaging the starter an spinning the engine over .

2006 Chevrolet... | Answered on Nov 27, 2017

Merely spritzing disinfectant is ineffective. You have to spray it into the high level air intake at the base of the windshield while running the A/C on high. Shut down the A/C and allow the disinfectant to attack mold in the ducts. As an added step, check the discharge end of the ducts for accumulated leaves and debris that prevent free flow and subsequent drying.

2006 Chevrolet... | Answered on Nov 23, 2017

Not finding what you are looking for?

1,302 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts


Level 3 Expert

83940 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22441 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Equinox Chevrolet

  • Equinox Chevrolet

Most Popular Question

torque specs front wheel hub 2006

  • Cars & Trucks