20 Most Recent 1984 Nissan Pickup Questions & Answers


get the service and repair manual from the given link and fix the problem by you own http://toolsnyou.com/

1984 Nissan... | Answered on Dec 15, 2017


this is a lis from auto zone that can help u fix that Shaun Priority Action Part Type Cause 1 Inspect Battery Damaged or faulty battery and/or connections. grey_line.gif 2 Inspect Coil - Ignition Damaged or faulty ignition coil or ignition coil circuit. grey_line.gif 3 Inspect Fuel Filter Clogged or dirty fuel filter grey_line.gif 4 Inspect Fuel Injector Pressure Regulator Faulty fuel injector pressure regulator or circuit. grey_line.gif 5 Inspect Fuel Pump Improperly functioning fuel pump or circuits. grey_line.gif 6 Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). grey_line.gif 7 Inspect Control Module-Ignition Faulty ignition control module or circuit. grey_line.gif 8 Inspect Solenoid Switch Damaged or faulty solenoid switch or solenoid switch circuit. grey_line.gif 9 Inspect Starter Damaged, worn, defective, or faulty starter or starter related circuit. grey_line.gif 10 Inspect Neutral Safety Switch Damaged or faulty neutral safety swittch or circuit. grey_line.gif 11 Inspect Fuse Corroded, burned, or shorted fuse may be interupting power source. grey_line.gif 12 Inspect Fusible Link Corroded, burned, or shorted fusible link may be interupting power source. grey_line.gif 13 Inspect Battery Cable Corroded, broken or poorly connected battery cable. grey_line.gif 14 Inspect Spark Plug Wire Loom - Performance Improperly adjusted or worn/malfunctioning carburetor. grey_line.gif 15 Inspect Distributor Cap Loose or cracked distributor cap grey_line.gif 16 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. grey_line.gif 17 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. grey_line.gif 18 Inspect Fuel Injector Plugged, dirty or poorly connected fuel injector. grey_line.gif 19 Inspect Ignition Switch Worn, damaged or faulty ignition switch or circuit. grey_line.gif 20 Inspect Spark Plug Fouled, damaged or broken spark plug(s). grey_line.gif 21 Inspect Belt Incorrectly routed, adjusted(tensioned), missing or worn drive belt(s). grey_line.gif 22 Inspect Timing Belt Slipped or broken timing belt. grey_line.gif 23 Inspect Timing Set Slipped timing chain or worn timing gear(s). grey_line.gif 24 Inspect Fuel Tank Contaminated fuel from rusted or deteriorated fuel tank. grey_line.gif 25 Inspect Ignition Timing Incorrectly adjusted engine timing. grey_line.gif

1984 Nissan... | Answered on Dec 04, 2017


Did you check the timing? And how about timing advance?Water in tank from bad fuel? - happens all of a sudden - I think it is that based on description of what happened.

1984 Nissan... | Answered on Sep 20, 2017


Hi,I have a 85 nissan 720 4x4 2.4 with a Weber carb,never had to mess with the timing chain,but I do have another engine in it.These trucks have carb, issues,I got rid of my stock carb,couldn't do nothing with it,dealer said they were junk,so I put a Weber on it and it is so awesome now.The valves should be adjusted when the engine is hot.Could be the person that put the new timing chain in did it wrong.Here's a video I did after I installed the Weber carb.I never had a issue with having to adjust the valves.My old carb at the end would always idle high.The timing might not of been set right with the new timing chain.I have the factory repair manual I bought from the nissan dealer.I've had my Truck since 92,it's mint,speedo has 343,000 miles on it,Jasper engine has 53,000 miles on it,transmission is a remanufactured one,it has 3000 miles on it. 85 Nissan 720 4x4 2 4 Weber conversion Here's the carb I put on it.Here's a cool Nissan 720 site to join,it cost 5 bucks,I am a member,it's like a forum where 720 owners react with helping each other,you have a page where you can post pics of your ride and you can see other peoples 720's. http://720world.com/Weber Carb Conversion fits Nissan Pickup 83 86 Z24 Electric Choke Weber...

1984 Nissan... | Answered on Jul 07, 2017


you need to change the fuel gauge, fuel gauge goes bad so does the temp gauge, runs thru fuel gauge then to temp

1984 Nissan... | Answered on Jan 07, 2017


The first thing to do is check the engine for vacuum leaks, use a can or Carb cleaner, spray around the top near the intake gaskets and see if the engine idle changes, if it does you have a leak.

1984 Nissan... | Answered on Sep 19, 2016


Most likely the hydraulic line wasn't properly installed on the clutch slave cylinder or master cylinder, causing a leak. If the fitting was cross-threaded, it may have damaged either the hydraulic line fitting or the cylinder it goes into. Have whoever did the work fix this at their cost.

1984 Nissan... | Answered on Nov 24, 2015


The throttle/choke adjustment would correct this. If adjusting this does not make a difference then the carb will need to be rebuilt/replaced.

1984 Nissan... | Answered on Oct 17, 2015


Here's a link Samson to your firing order. Need Diagram of firing order for 1984 nissan pickup 720 Google Search Ihave a 85 Nissan 720 4x4 with the 2.4 engine,I have put a weber carb in mine,here's a video to see. 85 Nissan 720 4x4 2 4 Weber conversion If you want to join a cool Nissan site,here's a link,type in 720world.com,I am a member,

1984 Nissan... | Answered on May 24, 2015


Here's a link on a tool to use to fix your carburator,just don;t hit your foot. Sears com

1984 Nissan... | Answered on Apr 17, 2015


Hi Shane ,just answered your carb problem,here is the weber carb i installed,call me if you like.Click here to see. 85 Nissan 720 4x4 2 4 Weber conversion Here's another to see. 85 Nissan 720 4x4 Silverbullet 4 with Samantha YORKIE at the wheel look out

1984 Nissan... | Answered on Apr 10, 2015


Hi Shane,I have a 85 Nissan 720 4x4 with the 2.4 engine,had her for 22 years,our trucks have bad carburators,when I bought mine used,it had 108,000 miles on it and my carb started giving me problems,with the ideling,took it and had it rebuilt by 3 different carb shops at 200 a whop,no one could get it right,so I took it to the Nissan Dealer,they told me that they couldn't rebuilt it cause the bottom part is not assible,and told me that they were a bad design,so I did some research and found out about Weber carburators,so I bought one from redline,they cost 269.00 with kit,it's been on my 720 for 6 years now,plus I got a new remanufactured engine from Jasper engines and had a jasper installer put in in at the same time I put the new weber in.I spent a fortune trying to get the stock carb. right.I have 328,000 miles on the truck and it runs perfect.I plan on keeping my truck forever and that's the reason I put alot of money in it,A couple of months ago I redid the interior,it is now gray,was black,I live in Georgia and it is hot.Here's a video of mt Weber conversion,I have more pics and videos in you would like to see.My phone number is 706-580-6110 and my name is Tommy.https://www.youtube.com/watch?v=v5Fe9N0q2Kk

1984 Nissan... | Answered on Apr 10, 2015


on the bottom of the steering cover ther are 5 phillips tiped screws you may have to get down low to see them

1984 Nissan... | Answered on Jan 21, 2015

Not finding what you are looking for?
Cars & Trucks Logo

278 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14059 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pickup Nissan

  • Pickup Nissan

Most Popular Question

running rough

  • Cars & Trucks
Loading...