Dodge Car and Truck Repair Questions, Solutions and Tips - Vr2020

Dodge Cars & Trucks - Recent Questions, Troubleshooting & Support


Code P0181 stands for Fuel Temperature Sensor 'A' Circuit Malfunction. you will have to car repaired, this is not an easy fix or for DIY

Dodge Cars &... | Answered 4 hours ago


See is the turn signals working in the front if not the back. If they do work in the front, then its the connection to the back is no longer connected.

Dodge Cars &... | Answered 7 hours ago


Hey Jared..my name is Keith..and what you have is a bad door sensor..and you will have to see and figure out which one is bad..i had a bad sensor..after awhile the door ajar light would go out..and then when someone opened the passenger door..then the door ajar light would come back on..so i replaced the door sensor on the passenger side and it fixed the problem..i hope this helps

1997 Dodge... | Answered 12 hours ago


it is probably one of the relays in the tipm..hate to say that because the tipm is very expensive

Dodge Cars &... | Answered 14 hours ago


I do not know where the electronic circuit is for the wipers. The problem is that the capacitor is not charging up so that it discharges to make your wipers work intermittently.

Dodge Avenger... | Answered 15 hours ago


P0127 is your IAT (intake air temp)
P2274 is an 02 sensor stuck & making your PCM (power control module) your vehicle's computer throw multiple codes when actually theres nothing wrong but one or two small things. i had a 2000 chevy dually do the same thing. i would replace the IAT sensor ($19.20), the 02 sensors, theres 2 of them one upstream & one downstream...i would replace them both IF after replacing the IAT sensor doesnt solve youre problem.

Dodge Cars &... | Answered Yesterday


I’m assuming it’s in the fuse panel under the hood. Take the cover off and read the diagram and see if or where it’s listed in there

Dodge Cars &... | Answered Yesterday


My info shows 6 cylinder. It does say 225.
ignition timing--2 1/2 degrees btdc

Dodge Cars &... | Answered Yesterday


I don't know, use a tape measure and measure the length. Your local auto store may have the correct cable. In the past, I have made my own cables, I used the old cable for size and length as pattern, then put new ends on it. The auto store has that type cable on spools, you just tell them the length and size and they cut it to length. I'd have to look at your cable, some have sensors. I'd have to look at it.
As far as the cable, if you crimp new ends, make darn sure you get a good crimp on it.

Dodge Cars &... | Answered Yesterday


Take it to a tire shop and get your tire balance checked
Balance weighs could get lost over the time and you won’t notice the vibration unless you are missing those weights.

Dodge Cars &... | Answered Yesterday


Sounds like the car thinks it has been stolen. Dealer will need to reset the system. The autozone cheap computers will not reset theft warning systems.

Dodge Cars &... | Answered 2 days ago


Pull the dipstick and check your oil level immediately!!! Do not drive this without checking the oil level.

Dodge Cars &... | Answered 2 days ago

Not finding what you are looking for?
Dodge Logo

116,838 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,238 Questions

1999 Dodge Durango
1999 Dodge Durango

-936 Questions

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

2000 Dodge Durango
2000 Dodge Durango

1,574 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,468 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...